Jump to content
Ad: Genuine BMW parts & accessories from the BMW official store on eBay ×

Suspension help needed please.

Moggy

By Moggy,
in BMW X5 Series Forum

 Share

Recommended Posts

Moggy Rookie

Moggy

Posted
Posted
Can you help please. My e70 has been suspended on ramp for about 3 weeks with the wheels off. Today I took it off the ramp and the rear suspension is at its lowest on both sides. Not only that but the compressor is not coming on. I have checked the dashboard 40amp fuse and the 10amp in the boot but all appears well. Does anyone have any suggestions as to whats gone wrongring. It worked perfectly well prior to going on the ramp.
Thanks
Greydog Grand Master

Greydog

Posted
Posted

Morning Duncan

Have you removed the fuses and checked them or visually inspected them? Is there power at the compressor? What information is the car giving you through the On Board Diagnostics?

Check the level sensors are OK not sticking the knee joint should be pointing towards the wheel I have seen where the suspension has been fully or overextended, they fold the wrong way, so nothing works

If Fuses Relay sensors and controller are OK then the compressor may have failed. A Diagnostic session will tell you for sure

Dave

Latest Deals

BMW Official Store for genuine BMW parts & accessories

Disclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via eBay links

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing




  • Latest Topics

    1. 2

      Connectors in the boot next to the battery

      Hi Dave - Thank you got the excellent advice and information. Could you tell me where the main fuse box is (never had a BMW before)? We have a friend coming over to scan the car on Thursday so hopefully sort out the issues or at least know what to fix first. Thanks once again - Kind regards Andrew
      Andrewkuk in BMW 1 Series Forum
    2. 2

      Connectors in the boot next to the battery

      Morning Andrew Welcome to the Forum looks like your missing a module rear camera or PDC could be a Towing Module Not sure about BCM (I assume this is Body Control Module?) BMW 1.4.0 or ISTA/INPA should/normally show Greyed out Modules as not communicating allowing indentification of Failed units The Footwell Control Module was a common issue on several models and a simple change whether you go new or recycled it will cause a Tamper Dot by the mileage, so your new unit will need to be registered to your chassis and the mileage matched to your car. Junction Box Electroncs is the next biggy mainly due to where it is situated. Dont forget check or better still change the Fuel Pump Relay one of the common faults Also disconnect the modules check the connectors for signs of corrosion on pins give every thing a clean and spray of electrical contact cleaner and put it back. I have fixed several this way. Good Luck Dave
      Greydog in BMW 1 Series Forum
    3. 1

      Z3 airbag wiring,

      Hi. Do you have a light on the dash? It could be that someone fitted an emulator ?
      X5smw in BMW Z3 & Z4 Series Forum
    4. 1

      Z3 airbag wiring,

      I'm am sorry if I am doing this incorrectly but I have searched and not found anything related to this but I am still learning all of this. Does anyone know about the yellow airbag/ seat belt connector under the driver’s seat? I am sure the previous owner has changed this but I am wondering if anyone has seen this before? If so, should I remove the butt connectors and solder the wires? Should the wires be twisted all the way to the yellow connector? Any help is greatly appreciated. Thanks, JayMe
      JayMe in BMW Z3 & Z4 Series Forum
    5. 2

      Connectors in the boot next to the battery

      Hi - I have a 2007 1.6L Petrol 1 series and it has wire connectors in the boot near the battery but I don't know what they are meant to connect to. Are they just spare or is there a part missing? The car currently not starting but we think it is a BCM fault but just wanted to know what the cables in the boot are meant for. Any help would be greatly appreciated be gratefully appreciated as we can't read the fault codes as we think the BCM is faulty and the car won't idle properly but there might be some other issue. Regards Andrew
      Andrewkuk in BMW 1 Series Forum

  • Recent Achievements

    • First Post
      Andrewkuk
      Andrewkuk earned a badge
      First Post
    • Conversation Starter
      JayMe
      JayMe earned a badge
      Conversation Starter
    • Conversation Starter
      Andrewkuk
      Andrewkuk earned a badge
      Conversation Starter
    • One Month Later
      DAW90
      DAW90 earned a badge
      One Month Later
    • First Post
      Max123
      Max123 earned a badge
      First Post

×
×
  • Create New...

Forums

News

Membership