Jump to content
Ad: Genuine BMW parts & accessories from the BMW official store on eBay ×

318Is Coupe Wont Sit Idle

coco123

By coco123,
in New Members Welcome

 Share

Recommended Posts

coco123 Newbie

coco123

Posted
Posted

Hi new to this site am looking for some info my 318is coupe just wont sit right when idle revs are up and down just had service still doing a freind reackons might be lambda sensor any one know anything about this any info would be great thanks

BigAl Mentor

BigAl

Posted
Posted

Welcome, Enjoy the forum, I would take the car back to where you had it serviced, to rectify the problem, good luck

TheMajor Rookie

TheMajor

Posted
Posted

Could be your Mass Air Flow (MAF) sensor or your air control valve, normally the MAF sensor just needs a clean with some spray and the air control valve can get jammed up with carbon, just needs taking off and cleaned with a wire brush and some WD 40.

Hope that helps, good luck!

Steve B Contributor

Steve B

Posted
Posted

just a note. NEVER use WD40 in your ICV, throttle bodies or anything that needs just air, WD40 is an OIL, and can cause serious problems with an engine, use brake cleaner or throttlebody / carb cleaner, it evaporates leaving no residue and costs about the same if not less that a can of WD. just a word of advice, check your ICV, MAF, and lift your engine cover to check the pipe that runs over the top hasnt collapsed... or take it back to the service station to rectify it.

Latest Deals

BMW Official Store for genuine BMW parts & accessories

Disclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via eBay links

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing




  • Latest Topics

    1. 6

      X3 2.0 automatic

      Many thanks for the help I've hot the car booked in for a full health check but it seem that the transfer box oil as not been changed for nearly 3 years so I'm hoing to do that first to see if it helps
      Davesally in BMW X3 Series Forum
    2. 6

      X3 2.0 automatic

      hi , I had very similar problem a while back, and after a lot of testing with vista, it turned out to be a front R/H wheel , speed/wheel sensor. when it all was happing lots of codes were coming up gearbox, diff front and back, transever box,plus many more, didn't look good, but there was one code that repeatedly came up at the top of the list, at this point it was becoming undriveable ,it just didn't seem that a wheel sensor could cause all these codes. So I went got two wheel speed sensor, replaced driver side front, the problem never came back, the sensor controls so many systems ,cleared all codes, happy days, I could have pulled the car apart for nothing, and got nowhere, except an empty wallet. hope this helps you or someone.
      ANDYORAC in BMW X3 Series Forum
    3. 0

      Water leak at sharkfin aerial

      Has anybody experienced water leakage passed the sharkfin aerial to roof joint face.
      VFullard in BMW 4 Series Forum
    4. 7

      105C thermostat replacement

      As I understand the wiring diagrams and operation Item 9 on the thermostat housing is the sensor which sends its signal to the ECU for interpretation with information from the map sensor. Information from item 12 (1st drawing ) is also used to provide average temp across the cooling system. As far as I am aware the Thermostst is independent of the sensors and operated by expanding wax material internally
      Greydog in BMW 7 Series Forum
    5. 13

      BMW 318i boot locked can’t get into

      Errr not clear here Donald Plastic "L's" with short rubber hoses ??? Distilled water/Ionised water should only be used in an old style lead acid battery. The Rad and engine coolining system should be filled with the correct coolant mix to prevent cavitation and the danger of freezing in low temps. Coolant should be part of the cars regular maintenance and changed every 3 years or so. At that time all hoses and connectors should be inspected and changed where necessary to keep everything in tip top condition. Changing parts can cause as many problems as you may think your solving
      Greydog in BMW 3 Series Forum

  • Recent Achievements

    • Week One Done
      Davesally
      Davesally earned a badge
      Week One Done
    • One Year In
      Backmarker
      Backmarker earned a badge
      One Year In
    • Week One Done
      Karlos70
      Karlos70 earned a badge
      Week One Done
    • Week One Done
      DDONNY
      DDONNY earned a badge
      Week One Done
    • Collaborator
      Dimitris
      Dimitris earned a badge
      Collaborator

×
×
  • Create New...

Forums

News

Membership