Jump to content
Ad: Genuine BMW parts & accessories from the BMW official store on eBay ×

Need Help With My Bimmer Please ;-)

Reamo318IS

By Reamo318IS,
in New Members Welcome

 Share

Recommended Posts

Reamo318IS Newbie

Reamo318IS

Posted
Posted

Hi everyone...just bought a 1998 BMW 318 IS and would like some advice with some issues it has....1st It has developed an intermittant misfire...probs needs new plugs but didnt know if they suffer from this....2nd the Blower Motor is also intermittant...isit likely to be the motor or controls?? ....lastly the fuel gauge has stopped working??? Any help/advice would help and be greatly appreciated...thanks matt

IanIOM Experienced

IanIOM

Posted
Posted

Hi Matt

The is is a cracking car! Give the old gal a service first,then report back on the miss fire!

Did the fuel gauge work then stop? Or never work?

Snypa-D Grand Master

Snypa-D

Posted
Posted

Welcome to BMWOC :)

Misfire could be plugs or a dodgy coil pack,the heater is more than likely the 'hedgehog' resistor,and fuel gauge is probably a fuse blown ????

G4VHD Grand Master

G4VHD

Posted
Posted

Snypa and Ian covered it mate

Get the is in for a service and see if it changes anything

Guest Mister Dabsy

Guest Mister Dabsy

Posted
Posted

A blown fuse wouldn't cause it.

Where is the misfire? Is it noticeable on idle or higher revs?

As it is a four-potter it would be hard to eliminate a coil-pack by just pulling off but bang a high-voltage meter across "Earth" and its "Low tension" feed and notice any shortfall...

... Other items to inspect are:

MAF

TPS

CPS

... And any air-leaks via intake hoses.

Good luck ;)

Reamo318IS Newbie

Reamo318IS

Posted
  • Author
Posted

Hi again guys...the only problem left is the blower controls...ive had a look at the wiring and it looks okay...whats the deal with this hedgehog resistor? How do i find and test this resistor? Thanks matt

Reamo318IS Newbie

Reamo318IS

Posted
  • Author
Posted

Hi again guys...the only problem left is the blower controls...ive had a look at the wiring and it looks okay...whats the deal with this hedgehog resistor? How do i find and test this resistor? Thanks matt

Snypa-D Grand Master

Snypa-D

Posted
Posted

Looks like Dabs covered everything else :)

Hedgehog resistor is in the passenger footwell on the right hand side,they are a common failure...............have a look n YouTube for a vid to find it,its an easy change :)

Latest Deals

BMW Official Store for genuine BMW parts & accessories

Disclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via eBay links

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing




  • Latest Topics

    1. 7

      105C thermostat replacement

      As I understand the wiring diagrams and operation Item 9 on the thermostat housing is the sensor which sends its signal to the ECU for interpretation with information from the map sensor. Information from item 12 (1st drawing ) is also used to provide average temp across the cooling system. As far as I am aware the Thermostst is independent of the sensors and operated by expanding wax material internally
      Greydog in BMW 7 Series Forum
    2. 13

      BMW 318i boot locked can’t get into

      Errr not clear here Donald Plastic "L's" with short rubber hoses ??? Distilled water/Ionised water should only be used in an old style lead acid battery. The Rad and engine coolining system should be filled with the correct coolant mix to prevent cavitation and the danger of freezing in low temps. Coolant should be part of the cars regular maintenance and changed every 3 years or so. At that time all hoses and connectors should be inspected and changed where necessary to keep everything in tip top condition. Changing parts can cause as many problems as you may think your solving
      Greydog in BMW 3 Series Forum
    3. 13

      BMW 318i boot locked can’t get into

      Update: I checked my battery and it charged in 5 minutes, so I don't have to find another alternator. All seems to be OK except for the plastic "L"s with a short rubber hose that bypass the HV/AC solenoid. Those get clogged after @ 150,000-190,000 miles (if distilled water wasn't used) and cause air pockets that try to burst radiators. I have a few more brass "L"s, so now I can throw the plastic ones away. I have to be careful I don't fog the windows though, without heat or cool.
      DDONNY in BMW 3 Series Forum
    4. 7

      105C thermostat replacement

      You are absolutely right. The strange thing is that when I put the chassis number on the realoem it shows that the temp sensor is not applicable on my vehicle. I will physically check for a sensor. In the meantime, do you think that the removal of the MAP activated thermostat will effect the temp gauge on the dial instrument item 6? I am tempted to add a dummy resistor , 11.5ohms - 13watts , to simulate the MAP thermostat. Your thoughts?
      Dimitris in BMW 7 Series Forum
    5. 14

      X5 e53 reverse sensors video required please

      What's Brazillian for BIG THUD 🤣🤣 Dave
      Greydog in BMW X5 Series Forum

  • Recent Achievements

    • Week One Done
      Karlos70
      Karlos70 earned a badge
      Week One Done
    • Week One Done
      DDONNY
      DDONNY earned a badge
      Week One Done
    • Collaborator
      Dimitris
      Dimitris earned a badge
      Collaborator
    • Week One Done
      DAW90
      DAW90 earned a badge
      Week One Done
    • First Post
      jn1253
      jn1253 earned a badge
      First Post

×
×
  • Create New...

Forums

News

Membership