Tarmacterror

This is the benefits of joining the bestest beemer forum out there Let me know how you get on mate

Hah I like that I love polar bears If the first method isn't working then try the 2nd listed here. How to bleed the cooling system. 1.Jack the front of the vehicle up onto stands as high as possible, 2.Turn the ignition on to Aux 2, Engine OFF, heater on fan setting 1 and temperature fully hot, 3.Remove the rad cap/expansion cap,remove the bleed screw from the radiator and IF you have them the bleed screw(s) from the thermostat housing/top hose, return pipe or EGR thermostat. 4.Fill the radiator/expansion tank up and keep pouring till there are no more air bubbles coming out from the bleeds, using a funnel that fits tight in the expansion tank neck and filling it full of water will help push any troublesome air out, when good you can then install the bleeds and tighten down(don't snap them),ensure the rubber O-rings/seals are still on the screws/on the bleed holes. 5.Suck some water out so it's not full to the brim, start the car up and check coolant shoots out of the small hole on the inside of the expansion tank neck when the revs are held up, if it does then replace the cap and then run the car up and check for heat from the vents when the car is warm, then carry on and check if over heating still persists. You may have to bleed troublesome cars again afterwards.(but very rare). 6.If all is good then check the water level again in the morning when cool. or Ignition on, heater set to hot, bleed screw out. Pull the top hose off the radiator. Pour coolant SLOWLY down the rad hose a litre at a time. When the coolant is building up in the hose, hold it above the level of the rad hose stub and keep adding it. When coolant starts to dribble from the rad, refit the hose. You may find that coolant starts to overflow from the rad cap orifice - if it does, just screw the cap back on. Once you've done that, the engine and radiator are full of coolant - the little air pockets that might be left will come through the bleed screw. After the vehicle is bled you should check that when the revs are held up you get a flow of coolant shooting out of the hole in the inside of the expansion tank neck, this will help tell you if the water pump is circulating, then run the car up and check the lower radiator hose gets hot.

I had same problem on my 530 sport,I changed the radiator which was all blocked up from many years was told it was the original one! also replaced the thermostat and the heater resistor and it done the trick no problems after that. You could just try bleeding the cooling system who knows might just be a quick fix

Welcome aboard this is the forum with real enthusiasts your in good hands😀

Try dynavin store they have got a nice updated unit with so many cool features on it and is a perfect factory Finish look, money well spent and add value to the car

I have used gsf parts in the past and they have some good quality parts give them a try aswell

Go for the Osrams or Phillips xtreme both these are excellent performers

Nice1 daz

How do I get hold of a halfords card I have lost mine

Cars back on for sale quick grab a bargain!!

Did the alarm not go off unless its faulty? worth getting it checked out mate

All i can say is as long as service is performed at the correct times these cars will keep on munching miles :D

What are you on there jeffthro??

Hi, welcome to the club, firstly hope all goes well with new job. This is the right place for all your bmw info Just let us know we all here to help out, serious enthusiasts only hehee

BBS all the way

It's your call, ultimately. The fuel does have a lot of extra bells and whistles, but that's not to say 'ordinary' fuels don't. Most of the petrol and diesel fuels sold in the UK are formulated to clean and protect your engine – even the stuff sold at supermarkets. Some fuels are better than others, obviously, but if you value performance and economy there's probably no harm in investing in a fuel you think will give you the best value for money in the long term.

Looks mint ;) they really should have come factory standard just like the e39's

Welcome to the club. Check out this company they will supply everything you need http://www.mstyle.co.uk/acatalog/info_D04MS100.html

Cars can always be replaced at least you ok

looks mint good job man soo when can i bring mine round hehee :lol:

Hi, welcome aboard mate. wow you had some nice motors n what can i say the m3 csl is a dream machine :rolleyes: How come you not had the legendary e39 m5 in the collection

Welcome to the club. Send some pics in and enjoy the new ride!

Decided to keep my car :rolleyes: saving up for the m5 and gonna keep this as my daily runabout. some1 could have had a bargain but its all good cos its such a joy to drive i'm gonna take it for a nice run on wkend